CDT Audio
Amplifiers
CDT Audio SQA 4100
Amplifier
For years our faithful CDT Audio customers
have requested a "High Quality" power amplifier to drive
their CDT Speakers. Finally, check out our brand new
SQA 4100 amp, our newest 2008' release.
See our special Packages
below**
The CDT Audio Superlative Quality
SQA-4100 Amplifier
The CDT clean looking amplifier line
adheres to the most stringent engineering principles to
bring you an unparalleled listening experience in the
automotive environment. We offer a very flexible multi use
amplifier Guaranteed values and a detailed power
specification of each model. Typical power values are
approximately much higher than rated, a specific individual
birth/test sheet is supplied with each amplifier.
SQA-4100 Mosfet Class AB amplifier have internal variable
24/db per octave high and low pass adjustable crossovers.
Built-in subsonic filter. 5 way protections. 2 Ohm Stable
circuits. Soft Start/mute circuit. Trimode output
configuration. Daisy chain through output RCA. Input level
controls. The amplifier utilize massive robust power
supplies and amplification stages for the maximum installed
flexibility, impact and reliable performance.
SQA-4100 is a four channel dually bridgeable amp and
provides a continuous maximum of 150 Watts per channel from
each of 4 channels into 2 Ohms. CDT SQA-4100 will also
provide a continuous maximum of 300 Watts bridged from each
of two pairs of channels into 4 Ohms
Specifications
4 Ohm - 110W x 4CH
2 Ohm - 160W X4CH
Mono Bridge at 4 Ohms - 320W x 2CH
Frequency response-3dB - 5Hz - 60kHz
S/N Ratio(A-Weight) - _100dB
Channel Separation - _65dB
Variable Input Gain Control - 0.15V~5.0V
Input Impedance - 47 k?
Crossover S/W - LP/FULL/HP
Variable Hi-Pass (12dB) - 30Hz~500Hz
Variable Low-Pass (12dB) - 30Hz~500Hz
Variable Subsonic Filter (12dB)- 15Hz~45Hz
ALL CDT Audio
Speakers on Sale
| 
